Mk-diamond MK-130-3 Instrukcja Użytkownika

08.2012MK-130/3 Hand Held Wet Core DrillOWNER’S MANUAL & OPERATING INSTRUCTIONSwww.mkdiamond.comCaution: Read all safety and operating instruction

10ON-OFF SETTINGOVERLOAD PROTECTION The machine is equipped with an ON/OFF switch with a lock button which allows a soft start-up and accurate spot-dr

11The water pressure should not be higher than 3 bar.When drilling “overhead,” you have to control the water at the drill hole by us-ing a water sucti

12TROUBLESHOOTINGError Possible Cause Error Recoverymachine does not work main current supply interrupted plug in another electric applianceline cord

13NOTES

14ORDERING INFORMATIONYou may order MK Diamond products through your local MK Diamond distributor, or, you may order direct from MK Diamond.When order

15CONTACTPlease contact MK Diamond Products, Inc. Customer Service Department with any questions you might have regarding distributors, parts or servi

MK-130/3 Handheld DrillOWNER'S MANUAL & OPERATING INSTRUCTIONS MK Diamond Products, Inc.1315 Storm ParkwayTorrance, CA 90501Toll-Free: (800)

2INTRODUCTION Congratulations on your purchase of a MK-130/3 Handheld Drill. We are certain that you will be pleased with your purchase. MK Diamond

3TABLE OF CONTENTS SAFETYSafety Messages 4 General Safety 4-5California Proposition 65 Message 6 Safety Label 7Pre-Start Safety 7-8Product Speci

4Failure to follow instructions in this manual may lead to serious injury or even death! This equipment is to be operated by trained and qualied pers

5• Use the right tool. Do not use a tool or attachment to do a job for which it is not recommended. Do not alter the tool. Maintain all tools with

6Grinding/cutting/drilling of masonry, concrete, metal and other materials with silica in their composition may give off dust or mists containing crys

7PRE-START SAFETY1. When drilling ceilings or walls make sure you will not cut through electrical mains, gas or water pipes. Use metal detection s

8General SpecificationsMotor 120VWatts 1700Frequency 40-60HzSpeed 3 speedBit Capacity 3” (76mm) hand-held6” (152mm) rig mountedConnecting Threads 1-1

9Maximum Drilling DiameterGear Diameter1st 6”2nd 2-3/4”3rd 1-1/2”Load Speed 1st Gear 600 RPMLoad Speed 2nd Gear 1300 RPMLoad Speed 3rd Gear 2800 RPMIN